LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Control System (DTC/Circuit Diagnosis) (5.6L) (5 Of 6)) >> DTC/Circuit Diagnosis >> DTC P1197: Out Of Gas >> DTC Diagnosis Procedure

DTC Diagnosis Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REFUEL THE VEHICLE 
    1. Refuel 10 liter (10 US qt, 8 imp qt).
      CAUTION: Never refuel more than 10 liter.
    2. Start the engine and keep the engine speed at 3, 000 rpm for 30 seconds.
      NOTE: For best results, warm up the engine until "COOLAN TEMP/S" on "DATA MONITOR" of CONSULT reaches at least 70 deg.C (158 deg.F).
    3. Turn ignition switch OFF and wait at least 10 seconds.
    4. Turn ignition switch ON.
    5. Turn ignition switch OFF and wait at least 10 seconds.
    6. Turn ignition switch ON.
    7. Erase the DTC.
    8. Start the engine and let it idle at least 60 seconds.
    9. Perform the confirmation procedure again. Refer to DTC Description .

    Is 1st trip DTC detected?

    YES

    GO TO 2.

    NO

    INSPECTION END

  2. CHECK LOW PRESSURE FUEL PUMP 

    Refer to Component Function Check .

    Is inspection result normal?

    YES

    GO TO 3.

    NO

    Repair or replace error-detected parts.

  3. CHECK HIGH PRESSURE FUEL PUMP 

    Refer to Component Function Check .

    Is inspection result normal?

    YES

    Check the fuel hose for disconnection and looseness.

    NO

    Repair or replace error-detected parts.

scientia non olet · About LEMON Manuals