DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK DTC PRIORITY
If DTC P1090 or P1093 is displayed with DTC P1091 first perform the trouble diagnosis for DTC P1091.
Is applicable DTC detected?
YES
Perform diagnosis of applicable. Refer to DTC Description .
NO
GO TO 2.
- PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is 10 V or more at idle.
GO TO 3.
- PERFORM DTC CONFIRMATION PROCEDURE
- Start engine and let it idle for 10 second.
- Keep the engine speed at approximately 3, 500 rpm for at least 10 seconds under no load.
- Check DTC.
Is DTC detected?
YES
Proceed to Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Intermittent Incident .
NO
Confirmation after repair: INSPECTION END