Component Inspection (Intake Air Temperature Sensor)
WARNING: This page is about a different variant/trim than selected.
- CHECK INTAKE AIR TEMPERATURE SENSOR
- Turn ignition switch OFF.
- Disconnect mass air flow sensor harness connector.
- Check resistance between mass air flow sensor terminals as per the following.
Terminals
Condition
Resistance (kOhm)
1 and 2
Temperature [ deg.C (deg.F)]
25 (77)
1.94 - 2.06
Is the inspection result normal?
YES
INSPECTION END
NO
Replace mass air flow sensor (with intake air temperature sensor). Refer to Removal and Installation .