DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK DTC PRIORITY
If DTC P0125 is displayed with P0117 or P0118, first perform the trouble diagnosis for DTC P0117, P0118.
Is applicable DTC detected?
YES
Perform the diagnosis of the applicable. Refer to DTC Index .
NO
GO TO 2.
- PRECONDITIONING
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
GO TO 3.
- CHECK ENGINE COOLANT TEMPERATURE SENSOR 1 FUNCTION
WITH CONSULT
- Turn ignition switch ON.
- Select "DATA MONITOR" mode with CONSULT.
- Check that "COOLAN TEMP/S" is above -10 deg.C (14 deg.F).
WITH GST
Follow the procedure "With CONSULT" above.
Is the temperature above -10 deg.C (14 deg.F)?
YES
INSPECTION END
NO
GO TO 4.
- PERFORM DTC CONFIRMATION PROCEDURE
- Start engine and run it for 65 minutes at idle speed.
If "COOLAN TEMP/S" increases to more than -10 deg.C (14 deg.F) within 65 minutes, stop engine because the test result will be OK.
CAUTION: Never overheat engine. - Check 1st trip DTC.
Follow the procedure "With CONSULT" above.
Is 1st trip DTC detected?
YES
NO
To check malfunction symptom before repair: Refer to Intermittent Incident .
NO
Confirmation after repair: INSPECTION END
- Start engine and run it for 65 minutes at idle speed.