Component Inspection (Throttle Position Sensor)

1. Turn ignition switch OFF.
2. Reconnect all harness connectors disconnected.
3. Perform Description .
4. Turn ignition switch ON.
5. Set selector lever position to D.
6. Check the voltage between ECM harness connector terminals under the following conditions.

   ECM			Condition		Voltage (V)
   Connector	+	-
   	Terminal	Terminal
   F79	78 (TP sensor 1 signal)	85 (Sensor ground)	Accelerator pedal	Fully released	More than 0.36
   				Fully depressed	Less than 4.75
   	80 (TP sensor 2 signal)			Fully released	Less than 4.75
   				Fully depressed	More than 0.36

Is the inspection result normal?

YES

INSPECTION END

NO

GO TO 2.

Replace electric throttle control actuator. Refer to Removal and Installation .

INSPECTION END