Removal Of Liquid Gasket Sealant

WARNING: This page is about a different variant/trim than selected.

After removing nuts and bolts, separate the mating surface using Tool, and remove old liquid gasket sealant.

Courtesy of NISSAN NORTH AMERICA, INC.

Tool number

: KV10111100 (J-37228)

Tap seal cutter to insert it (1), and then slide it by tapping on the side (2) as shown.
In areas where Tool is difficult to use, use plastic hammer to lightly tap the part, to remove it.
CAUTION: If for some unavoidable reason tool such as screwdriver is used, be careful not to damage the mating surfaces.