LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 98 (Steering Control System (DTC/Circuit Diagnosis)) >> DTC/Circuit Diagnosis >> DTC C1607: Power Steering Control Module >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. PERFORM SELF-DIAGNOSIS 

    SYMBOL CONSULT

    1. Turn the ignition switch OFF to ON.
    2. Erase "Self Diagnostic Result" mode of "EPS".
    3. Turn the ignition switch OFF and wait for at least 10 seconds.
    4. Perform "Self Diagnostic Result" mode of "EPS".

    Is DTC "C1607" or "C1608" detected?

    YES

    Power steering control module is malfunctioning. Replace power steering oil pump assembly. Refer to Removal and Installation .

    NO

    Check pin terminal and connection of each harness connector for malfunctioning conditions.

scientia non olet · About LEMON Manuals