Removal and Installation: Installation
WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Perform "ADDITIONAL SERVICE WHEN REPLACING DIAGNOSIS SENSOR UNIT". Refer to Special Repair Requirement
.
Installation is in the reverse order of removal.
CAUTION:
- Do not reuse air bag diagnosis sensor unit bolts.
- The air bag diagnosis sensor unit must always be installed with label arrow mark "
" pointing toward front of vehicle for proper operation.
- Do not damage air bag diagnosis sensor unit harness connectors during installation.
- After installation is complete, check that no system malfunction is detected causing air bag warning lamp to illuminate.
- If a malfunction is indicated by air bag warning lamp after repair or replacement of malfunctioning parts, perform SRS final check. Refer to SRS Final Check .
- After replacing air bag diagnosis sensor unit, confirm using CONSULT that ECU discriminated number (identification number) or part number of new replacement air bag diagnosis sensor unit matches ECU discriminated number (identification number) or part number of replaced (old) air bag diagnosis sensor unit.
NOTE:
If ECU discriminated number or part number of new replacement air bag diagnosis sensor unit differs from ECU discriminated number or part number of replaced air bag diagnosis sensor unit, reconfirm parts information and verify that the correct air bag diagnosis sensor unit was installed.