Removal and Installation: Removal
WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative and positive battery terminals, then wait at least 3 minutes. Refer to Battery Disconnect .
- Remove the front air duct, then position upper radiator hose aside.
- Disconnect the harness connector from the crash zone sensor.CAUTION: Do not damage harness connector.
- Remove the nut, then remove crash zone sensor.CAUTION:
- Replace crash zone sensor if it has been dropped or sustained an impact.
- Do not strike crash zone sensor.
- Replace crash zone sensor if either driver air bag or front passenger air bag has been deployed.
- Do not reuse crash zone sensor nut.