Diagnosis Procedure
WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- Before servicing, turn ignition switch OFF, disconnect battery negative terminal, and wait at least 3 minutes or more. (To discharge backup capacitor.)
- Never use unspecified tester or other measuring device.
- CHECK DTC
Perform each inspection according to the displayed DTC.
Which DTC is displayed?
[B0099-86]
GO TO 4.
Other than the above
GO TO 2.
- CHECK HARNESS CONNECTOR
Check the harness connector.
Is the inspection result normal?
YES
GO TO 3.
NO
Replace harness connector.
- CHECK WIRING HARNESS
Check the wiring harness externals.
Is the inspection result normal?
YES
GO TO 4.
NO
Replace wiring harness.
- REPLACE SATELLITE SENSOR
- Replace satellite sensor. Refer to Removal and Installation .
- Perform DTC confirmation procedure. Refer to DTC Logic .
Is DTC detected?
YES
GO TO 5.
NO
Inspection End.
- REPLACE AIR BAG DIAGNOSIS SENSOR UNIT
- Replace air bag diagnosis sensor unit. Refer to Removal and Installation .
- Perform DTC confirmation procedure. Refer to DTC Logic .
Is DTC detected?
YES
GO TO 1.
NO
Inspection End.