DTC Confirmation Procedure

Will CONSULT be used?

Will CONSULT be used?

YES

GO TO 2.

NO

GO TO 5.

If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

GO TO 3.

With CONSULT

1. Turn ignition switch ON.
2. Select "P/N POSI SW" in "DATA MONITOR" mode with CONSULT. Then check the "P/N POSI SW" signal under the following conditions.

   Position (Selector lever)	Known-good signal
   N or P position	ON
   Except above position	OFF

Is the inspection result normal?

YES

GO TO 4.

NO

Proceed to Diagnosis Procedure .

1. Select "DATA MONITOR" mode with CONSULT.
2. Start engine and warm it up to normal operating temperature.
3. Maintain the following conditions for at least 50 consecutive seconds.
   CAUTION: Always drive vehicle at a safe speed.

   ENG SPEED	1, 100 - 6, 375 rpm
   COOLANT TEMP/S	More than 65°C (149°F)
   B/FUEL SCHDL	2.2 - 31.8 msec
   VHCL SPEED SE	More than 64 km/h (40 mph)
   Selector lever	Suitable position

4. Check 1st trip DTC.

Is 1st trip DTC detected?

YES

Proceed to Diagnosis Procedure .

NO

INSPECTION END

1. Turn ignition switch ON.
2. Check the voltage between ECM harness connector terminals.

   ECM				Condition		Voltage
   +		-
   Connector	Terminal	Connector	Terminal
   F14	83	E10	152	Selector lever position	P or N	Approx. 0 V
   					Except above	Battery voltage

Is the inspection result normal?

YES

To check malfunction symptom before repair: Refer to Intermittent Incident .

YES

Confirmation after repair: INSPECTION END

NO

Proceed to Diagnosis Procedure .