LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine Control System (DTC/Circuit Diagnosis) (3 Of 5)) >> DTC/Circuit Diagnosis >> DTC P052B: Intake Valve Timing Control >> Component Inspection (Camshaft position sensor)

Component Inspection (Camshaft position sensor)

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK CAMSHAFT POSITION SENSOR (PHASE)-1 
    1. Turn ignition switch OFF.
    2. Loosen the fixing bolt of the sensor.
    3. Disconnect camshaft position sensor (PHASE) harness connector.
    4. Remove the sensor. Refer to Exploded View .
    5. Visually check the sensor for chipping.
      GNSJMBIA0065Z-065Courtesy of NISSAN NORTH AMERICA, INC.

    Is the inspection result normal?

    YES

    GO TO 2.

    NO

    Replace camshaft position sensor (PHASE).

  2. CHECK CAMSHAFT POSITION SENSOR (PHASE)-2 

    Check the resistance camshaft position sensor (PHASE) terminals as per the following.

    Camshaft position sensor (PHASE)

    Resistance [ Ω at 25°C (77°F)]

    +

    -

    Terminals (Polarity)

    1

    2

    Except 0 or ∞Ω

    3

    2

    3

    Is the inspection result normal?

    YES

    INSPECTION END

    NO

    Replace camshaft position sensor (PHASE). Refer to Exploded View .

scientia non olet · About LEMON Manuals