LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine Control System (DTC/Circuit Diagnosis) (3 Of 5)) >> DTC/Circuit Diagnosis >> DTC P0520: EOP Sensor >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECONDITIONING 

    If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    GO TO 2.

  2. CHECK ENGINE OIL LEVEL 
    1. Turn ignition switch OFF.
    2. Check engine oil level. Refer to Inspection .

    Is inspection result normal?

    YES

    GO TO 3.

    NO

    Check engine oil leak. Refer to Inspection .

  3. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Start engine and let it idle for at least 5 seconds.
    2. Check 1st trip DTC.

    Is 1st trip DTC detected?

    YES

    Proceed to Diagnosis Procedure .

    NO

    To check malfunction symptom before repair: Refer to Intermittent Incident .

    NO

    Confirmation after repair: INSPECTION END

scientia non olet · About LEMON Manuals