LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine Control System (DTC/Circuit Diagnosis) (3 Of 5)) >> DTC/Circuit Diagnosis >> DTC P050A: Cold Start Control >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK DTC PRIORITY 

    If DTC P050A, P050E is displayed with other DTC, first perform the trouble diagnosis for the other DTC.

    Is applicable DTC detected?

    YES

    Perform diagnosis of applicable. Refer to DTC Index .

    NO

    GO TO 2.

  2. PERFORM IDLE AIR VOLUME LEARNING 

    Perform Idle Air Volume Learning. Refer to Description .

    Is Idle Air Volume Learning carried out successfully?

    YES

    GO TO 3.

    NO

    Follow the instruction of Idle Air Volume Learning.

  3. CHECK Intake system 

    Check for the cause of intake air volume lacking. Refer to the following.

    • Crushed intake air passage
    • Intake air passage clogging
    • Clogging of throttle body

    Is the inspection result normal?

    YES

    GO TO 4.

    NO

    Repair or replace malfunctioning part

  4. CHECK FUEL INJECTION SYSTEM FUNCTION 

    Perform DTC Confirmation Procedure for DTC P0171, P0174. Refer to DTC Description .

    Is the inspection result normal?

    YES

    GO TO 5.

    NO

    Proceed to Diagnosis Procedure for DTC P0171, P0174.

  5. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Turn ignition switch ON.
    2. Erase DTC.
    3. Perform DTC Confirmation Procedure.

      See DTC Description .

    Is the 1st trip DTC P050A, P050E displayed again?

    YES

    Replace ECM. Refer to Removal and Installation .

    NO

    INSPECTION END

scientia non olet · About LEMON Manuals