LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine Control System (DTC/Circuit Diagnosis) (3 Of 5)) >> DTC/Circuit Diagnosis >> DTC P0500: VSS >> DTC Description >> DTC Detection Logic

DTC Detection Logic

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

At 20 km/h (13 MPH), ECM detects the following status continuously for 5 seconds or more: The difference between a vehicle speed calculated by a output speed sensor transmitted from TCM to ECM via CAN communication and the vehicle speed indicated on the combination meter exceeds 15 km/h (10 MPH).

DTC

CONSULT screen terms

(Trouble diagnosis content)

DTC detection condition

P0500

VEH SPEED SEN/CIRC

(Vehicle speed sensor "A")

Diagnosis condition

Start engine and shift the selector lever to D range and drive the vehicle at least 5 seconds at 20 km/h (13 MPH) or more

Signal (terminal)

-

Threshold

At 20 km/h (13 MPH), ECM detects the following status continuously for 5 seconds or more: The difference between a vehicle speed calculated by a output speed sensor transmitted from TCM to ECM via CAN communication and the vehicle speed indicated on the combination meter exceeds 15 km/h (10 MPH)

Diagnosis delay time

-
scientia non olet · About LEMON Manuals