DTC Detection Logic

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

The cylinder No. signal is not sent to ECM for the first few seconds during engine cranking.
The cylinder No. signal is not sent to ECM during engine running.
The cylinder No. signal is not in the normal pattern during engine running.

DTC	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
P0340	CMP SEN/CIRC-B1 (Camshaft position sensor "A" circuit bank 1)	1	Diagnosis condition	Start engine and let it idle Start engine and maintaining engine speed at more than 800 rpm
			Signal (terminal)	Voltage signal transmitted from Camshaft position sensor (PHASE) to ECM
			Threshold	The cylinder No. signal is not sent to ECM for the first few seconds during engine cranking
			Diagnosis delay time	-
		2	Diagnosis condition	Start engine and let it idle Start engine and maintaining engine speed at more than 800 rpm
			Signal (terminal)	Voltage signal transmitted from Camshaft position sensor (PHASE) to ECM
			Threshold	The cylinder No. signal is not sent to ECM during engine running
			Diagnosis delay time	-
		3	Diagnosis condition	Start engine and let it idle Start engine and maintaining engine speed at more than 800 rpm
			Signal (terminal)	Voltage signal transmitted from Camshaft position sensor (PHASE) to ECM
			Threshold	The cylinder No. signal is not in the normal pattern during engine running
			Diagnosis delay time	-
P0345	CMP SEN/CIRC-B2 (Camshaft position sensor "A" circuit bank 2)	1	Diagnosis condition	Start engine and let it idle Start engine and maintaining engine speed at more than 800 rpm
			Signal (terminal)	Voltage signal transmitted from Camshaft position sensor (PHASE) to ECM
			Threshold	The cylinder No. signal is not sent to ECM for the first few seconds during engine cranking
			Diagnosis delay time	-
		2	Diagnosis condition	Start engine and let it idle Start engine and maintaining engine speed at more than 800 rpm
			Signal (terminal)	Voltage signal transmitted from Camshaft position sensor (PHASE) to ECM
			Threshold	The cylinder No. signal is not sent to ECM during engine running
			Diagnosis delay time	-
		3	Diagnosis condition	Start engine and let it idle Start engine and maintaining engine speed at more than 800 rpm
			Signal (terminal)	Voltage signal transmitted from Camshaft position sensor (PHASE) to ECM
			Threshold	The cylinder No. signal is not in the normal pattern during engine running
			Diagnosis delay time	-