Component Inspection

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CAMSHAFT POSITION SENSOR (PHASE)-I

Turn ignition switch OFF.
Loosen the fixing bolt of the sensor.
Disconnect camshaft position sensor (PHASE) harness connector.
Remove the sensor.

Visually check the sensor for chipping.

Courtesy of NISSAN NORTH AMERICA, INC.

Is the inspection result normal?

YES

GO TO 2.

Replace malfunctioning camshaft position sensor (PHASE). Refer to Exploded View .

CHECK CAMSHAFT POSITION SENSOR (PHASE)-II

Check the resistance camshaft position sensor (PHASE) terminals as per the following.

Camshaft position sensor (PHASE)		Resistance [ Ω at 25°C (77°F)]
+	-
Terminals (Polarity)
1	2	Except 0 or ∞
	3
2	3

Is the inspection result normal?

YES

INSPECTION END

Replace malfunctioning camshaft position sensor (PHASE). Refer to Exploded View .