Component Inspection

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK ACCELERATOR PEDAL POSITION SENSOR

Reconnect all harness connectors disconnected.
Turn ignition switch ON.

Check the voltage between ECM harness connector terminals under the following conditions.

ECM			Condition		Voltage (V)
Connector	+	-
	Terminal
E10	143	144	Accelerator pedal	Fully released	0.25 - 0.50
				Fully depressed	2.0 - 2.5
	150	151		Fully released	0.5 - 1.0
				Fully depressed	4.2 - 4.8

Is the inspection result normal?

YES

INSPECTION END

Replace accelerator pedal assembly. Refer to Removal and Installation .