DTC Confirmation Procedure
WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
GO TO 2.
- PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION 1 AND 2
- Turn ignition switch ON and wait at least 1 second.
- Shift selector lever to the D position and wait at least 3 seconds.
- Shift selector lever to the P position.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON and wait at least 1 second.
- Shift selector lever to the D position and wait at least 3 seconds.
- Shift selector lever to the P position.
- Turn ignition switch OFF, wait at least 10 seconds, and then turn ON.
- Check DTC.
Is DTC detected?
YES
Proceed to Diagnosis Procedure .
NO
GO TO 3.
- PERFORM DTC CONFIRMATION PROCEDURE FOR MALFUNCTION 3
- Turn ignition switch ON and wait at least 1 second.
- Shift selector lever to the D position and wait at least 3 seconds.
- Shift selector lever to the N or P position.
- Start engine and let it idle for 3 seconds.
- Check DTC.
Is DTC detected?
YES
Proceed to Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Intermittent Incident .
NO
Confirmation after repair: INSPECTION END