DTC Detection Logic
WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- ECM detects that the voltage of power source for throttle control motor is excessively low.
- ECM detects that the throttle control motor relay is stuck ON.
|
DTC |
CONSULT screen terms (Trouble diagnosis content) |
DTC detection condition |
|
|
P2100 |
ETC MOT PWR-B1 (Throttle actuator "A" control motor circuit/open) |
Diagnosis condition |
Start engine and let it idle |
|
Signal (terminal) |
Throttle control motor circuit |
||
|
Threshold |
ECM detects that the voltage of power source for throttle control motor is excessively low |
||
|
Diagnosis delay time |
- |
||
|
P2103 |
ETC MOT PWR-B1 (Throttle actuator "A" control motor circuit high) |
Diagnosis condition |
Ignition switch ON |
|
Signal (terminal) |
Throttle control motor circuit |
||
|
Threshold |
ECM detects that the throttle control motor relay is stuck ON |
||
|
Diagnosis delay time |
- |
||