DTC Confirmation Procedure
WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
GO TO 2.
- COMPONENT FUNCTION CHECK
With CONSULT
- Turn ignition switch ON.
- Select "DATA MONITOR" mode of "ENGINE" with CONSULT.
- Check that the "BRAKE SW" indication as per the following condition.
Monitor item
Condition
Indication
BRAKE SW
Brake pedal
Fully released
OFF
Slightly depressed
ON
Without CONSULT
- Turn ignition switch OFF.
- Check the stop lamp when depressing and releasing the brake pedal.
Brake pedal
Stop lamp
Fully released
Not illuminated
Slightly depressed
Illuminated
Is the inspection result normal?
YES
To check malfunction symptom before repair: Refer to Intermittent Incident .
YES
Confirmation after repair: INSPECTION END
NO
Proceed to Diagnosis Procedure .