LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Engine Control System (DTC/Circuit Diagnosis) (5 Of 5)) >> DTC/Circuit Diagnosis >> DTC P1564: ICC Steering Switch >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK DTC PRIORITY 

    If DTC P1564 is displayed with DTC P0605, first perform the confirmation procedure for DTC P0605.

    Is applicable DTC detected?

    YES

    Perform diagnosis of applicable. Refer to DTC Description .

    NO

    GO TO 2.

  2. PRECONDITIONING 

    If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    GO TO 3.

  3. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Turn ignition switch ON and wait at least 10 seconds.
    2. Press MAIN switch for at least 10 seconds, then release it and wait at least 10 seconds.
    3. Press CANCEL switch for at least 10 seconds, then release it and wait at least 10 seconds.
    4. Press RES/+ switch for at least 10 seconds, then release it and wait at least 10 seconds.
    5. Press SET/- switch for at least 10 seconds, then release it and wait at least 10 seconds.
    6. Press DISTANCE switch for at least 10 seconds, then release it and wait at least 10 seconds.
    7. Check DTC.

    Is DTC detected?

    YES

    Proceed to Diagnosis Procedure .

    NO

    To check malfunction symptom before repair: Refer to Intermittent Incident .

    NO

    Confirmation after repair: INSPECTION END

scientia non olet · About LEMON Manuals