Component Inspection (Cooling Fan Relay)

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK COOLING FAN RELAYS

Turn ignition switch OFF.
Remove cooling fan relay-2, -3.

Check the continuity between cooling fan relay-2, -3 terminals as per the following conditions.

Courtesy of NISSAN NORTH AMERICA, INC.

Cooling fan relay-2, -3		Conditions	Continuity
+	-
Terminal
5	3	12V direct current supply between terminals 1 and 2	Existed
		No current supply	Not existed
7	6	12V direct current supply between terminals 1 and 2	Existed
		No current supply	Not existed

Is the inspection result normal?

YES

INSPECTION END

Replace cooling fan relay.