LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 77 (Power Control System (IPDM E/R) (DTC/Circuit Diagnosis)) >> DTC/Circuit Diagnosis >> DTC B20A4: Etc Relay Stuck Off >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. PERFORM SELF DIAGNOSTIC RESULT 

    Perform "Self Diagnostic Result" of "IPDM E/R" using CONSULT.

    Is display history of DTC B20A4 CRNT?

    YES

    GO TO 2 .

    NO

    Refer to Intermittent Incident .

  2. CHECK ELECTRONIC THROTTLE CONTROL CIRCUIT FOR SHORT TO GROUND 
    1. Disconnect IPDM E/R connector F50.
    2. Check continuity between IPDM E/R connector F50 and ground.

      IPDM E/R

      Ground

      Continuity

      Connector

      Terminal

      F50

      57

      -

      No

    Is the inspection result normal?

    YES

    Replace IPDM E/R. Refer to Removal and Installation .

    NO

    GO TO 3 .

  3. CHECK ECM FOR SHORT TO GROUND 
    1. Disconnect ECM connector F13.
    2. Check continuity between IPDM E/R connector F50 and ground.

      IPDM E/R

      Ground

      Continuity

      Connector

      Terminal

      F50

      57

      -

      No

    Is the inspection result normal?

    YES

    Replace ECM. Refer to Removal and Installation .

    NO

    Repair or replace harness or connectors.