Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

CHECK "L" TERMINAL CIRCUIT (SHORT)
1. Turn ignition switch OFF.
2. Disconnect generator connector.
3. Turn ignition switch ON.
Does charge warning lamp illuminate?

YES

GO TO 2 .

NO

Refer to Work Flow (With DSS-5000P NI) or Work Flow (Without DSS-5000P NI) .

CHECK HARNESS CONTINUITY (SHORT CIRCUIT)

Turn ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Disconnect combination meter connector M24.

Check continuity between the combination meter harness connector M24 and ground.

Combination meter		Ground	Continuity
Connector	Terminal
M24	11		No

Is the inspection result normal?

YES

Replace the combination meter. Refer to Removal and Installation .

Repair or replace the harness or connectors.