Removal and Installation: Removal

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Remove front door finisher. Refer to Removal and Installation .
Remove bolt hole covers (A).

Courtesy of NISSAN NORTH AMERICA, INC.
Temporarily reconnect main power window and door lock/unlock switch (LH door) or power window and door lock/unlock switch RH (RH door).
Operate main power window and door lock/unlock switch (LH door) or power window and door lock/unlock switch RH (RH door) to raise/lower the door glass until the door regulator to glass bolts can be seen.
Remove door glass regulator to glass bolts (A).

Courtesy of NISSAN NORTH AMERICA, INC.
While holding door glass, raise it at the rear end and pull door glass out of door glass rubber run toward the outside of the door.

Courtesy of NISSAN NORTH AMERICA, INC.