LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 683 (Charging System (DTC/Circuit Diagnosis)) >> Circuit Diagnosis >> L Terminal Circuit (Short) >> Diagnosis Procedure >> Charging System (DTC/Circuit Diagnosis)

Charging System (DTC/Circuit Diagnosis)

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK "L" TERMINAL CIRCUIT (SHORT) 
    1. Turn ignition switch OFF.
    2. Disconnect generator connector.
    3. Turn ignition switch ON.

    Does charge warning lamp illuminate?

    YES

    GO TO 2.

    NO

    Refer to Work Flow (With 165-DSS-5000P) or Work Flow (Without 165-DSS-5000P) .

  2. CHECK HARNESS CONTINUITY (SHORT CIRCUIT) 
    1. Turn ignition switch OFF.
    2. Disconnect the battery cable from the negative terminal.
    3. Disconnect combination meter connector.
    4. Check continuity between the combination meter harness connector and ground.

      Combination meter

      Ground

      Continuity

      Connector

      Terminal

      M24

      11

      No

    Is the inspection result normal?

    YES

    Replace the combination meter. Refer to Removal and Installation .

    NO

    Repair or replace the harness or connectors.

scientia non olet · About LEMON Manuals