LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 682 (Engine Control System (DTC/Circuit Diagnosis) (15 Of 17)) >> DTC/Circuit Diagnosis >> DTC P34A4: Electric Intake Valve Timing Control Actuator >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK DTC PRIORITY 

    If DTC P34A4 is detected with DTC P34A7, first perform the confirmation procedure (trouble diagnosis) for DTC P34A7.

    Is DTC P34A7 detected?

    YES

    Perform diagnosis for P34A7. Refer to DTC Description .

    NO

    GO TO 2.

  2. PRECONDITIONING 

    If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    TESTING CONDITION:

    Before performing the following procedure, confirm that battery voltage is more than 10 V when ignition switch is ON.

    GO TO 3.

  3. PERFORM DTC CONFIRMATION PROCEDURE 
    1. Turn ignition switch ON.
    2. Check 1st trip DTC.

    Is DTC P31A4 detected?

    YES

    Proceed to Diagnosis Procedure .

    NO

    To check malfunction symptom before repair: Refer to Intermittent Incident .

    NO

    Confirmation after repair: INSPECTION END

scientia non olet · About LEMON Manuals