Removal and Installation - Rear Sonar Sensors

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

REMOVAL

Disconnect harness connector from rear sonar sensor.
Release rear sonar sensor finisher (1) pawls using suitable tool and remove rear sonar sensor (2) from rear sonar sensor finisher.

Courtesy of NISSAN NORTH AMERICA, INC.

: Pawl
Remove rear sonar sensor finisher (1) from rear bumper fascia (if necessary).

INSTALLATION

Installation is in the reverse order of removal.

CAUTION: If rear sonar sensor finisher is replaced, clean area before installation.