DTC Confirmation Procedure
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- PERFORM DTC CONFIRMATION PROCEDURE
- Press push-button ignition switch under the following conditions to start engine:
- Shift selector lever: In the P (Park) position
- Brake pedal: Depressed
- Wait 2 seconds after engine started.
- Check DTC in "Self-Diagnostic Result" mode of "BCM" using CONSULT.
Is DTC detected?
YES
GO TO Diagnosis Procedure .
NO
Inspection End.
- Press push-button ignition switch under the following conditions to start engine: