LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 679 (Security Control System (DTC/Circuit Diagnosis)) >> DTC/Circuit Diagnosis >> DTC B2604: Shift Position >> DTC Description >> DTC Detection Logic

DTC Detection Logic

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • If DTC B2604 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to DTC Logic .
  • If DTC B2604 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to DTC Logic .

DTC No.

Trouble diagnosis name

DTC detecting condition

Possible cause

B2604

PNP/CLUTCH SW

The following states are detected for 5 seconds while ignition switch is ON:

  • P/N position signal is sent from TCM but shift position signal input (CAN) from TCM is other than P (Park) and N (Neutral)
  • P/N position signal is not sent from TCM but shift position signal input (CAN) from TCM is P (Park) or N (Neutral)
  • Harness or connectors

    (CAN communication line is open or shorted.)

  • Harness or connectors

    (TCM circuit is open or shorted.)

  • TCM
  • BCM
scientia non olet · About LEMON Manuals