Diagnosis Procedure

1. Turn ignition switch ON.
2. Select "DETE/CANCEL SW" and "DETENT SW - IPDM" in DATA MONITOR mode with CONSULT.
3. Check "DETE/CANCEL SW" and "DETENT SW - IPDM" indication under the following conditions.

   Monitor item	Condition		Indication
   DETE/CANCEL SW	CVT Shift selector	In any position other than P (Park)	ON
   		P (Park)	OFF
   DETENT SW - IPDM	CVT Shift selector	In any position other than P (Park)	ON
   		P (Park)	OFF

Is the inspection result normal?

YES

Refer to Intermittent Incident .

NO

If DETE/CANCEL SW function is incorrect. GO TO 2.

NO

If DETENT SW - IPDM function is incorrect. GO TO 5.

1. Disconnect BCM connector and IPDM E/R connector.
2. Check continuity between CVT shift selector (park position switch) harness connector and BCM harness connector.

   CVT shift selector (park position switch)		BCM		Continuity
   Connector	Terminal	Connector	Terminal
   M78	6	M18	20	Yes

3. Check continuity between CVT shift selector (park position switch) harness connector and ground.

   CVT shift selector (park position switch)		Ground	Continuity
   Connector	Terminal
   M78	6		No

Is the inspection result normal?

YES

GO TO 3.

NO

Repair or replace harness.

1. Disconnect BCM.
2. Check connectors and terminals for deformation, disconnection, looseness or damage.

Is the inspection result normal?

YES

GO TO 4.

NO

Repair or replace as necessary.

1. Replace BCM. Refer to Removal and Installation .
2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT.

Inspection End.

Check continuity between CVT shift selector (park position switch) harness connector and IPDM E/R harness connector.

Is the inspection result normal?

YES

GO TO 6.

NO

Repair or replace harness.

1. Disconnect IPDM E/R.
2. Check connectors and terminals for deformation, disconnection, looseness or damage.

Is the inspection result normal?

YES

GO TO 7.

NO

Repair or replace as necessary.

1. Replace IPDM E/R. Refer to Removal and Installation .

Inspection End.