Component Function Check
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK COMBINATION METER INPUT SIGNAL
CONSULT
- Select "Data Monitor" mode of "METER/M&A".
- Select "BUCKLE SW".
- Check that the function operates normally according to the following conditions:
Monitor item
Condition
Status
BUCKLE SW
When seat belt LH is fastened
OFF
When seat belt LH is unfastened
ON
Is the inspection result normal?
YES
Inspection End.
NO
Refer to Diagnosis Procedure .