Automatic Drive Positioner (DTC/Circuit Diagnosis)

1. Turn ignition switch ON.
2. Check voltage signal between driver seat control unit connector and ground with oscilloscope.

(+)		(-)	Condition		Voltage (V) (Approx.)
Driver seat control unit
Connector	Terminals
B209	12	Ground	Steering column	Operate	Courtesy of NISSAN NORTH AMERICA, INC.
				Other than above	0 or 5

Is the inspection result normal?

YES

Replace driver seat control unit. Refer to Removal and Installation .

NO

GO TO 2.

1. Turn ignition switch OFF.
2. Disconnect driver seat control unit and telescopic motor.
3. Check continuity between driver seat control unit harness connector and telescopic motor harness connector.

   Driver seat control unit		Telescopic motor		Continuity
   Connector	Terminal	Connector	Terminal
   B209	12	M94	4	Yes

4. Check continuity between driver seat control unit harness connector and ground.

   Driver seat control unit		Ground	Continuity
   Connector	Terminal
   B209	12		No

Is the inspection result normal?

YES

GO TO 3.

NO

Repair or replace harness.

1. Connect driver seat control unit.
2. Turn ignition switch ON.
3. Check voltage between telescopic motor harness connector and ground.

   (+)		(-)	Voltage (V) (Approx.)
   Telescopic motor
   Connector	Terminals
   M94	5	Ground	Battery voltage

Is the inspection result normal?

YES

GO TO 5.

NO

GO TO 4.

1. Turn ignition switch OFF.
2. Disconnect automatic drive positioner control unit.
3. Check continuity between automatic drive positioner control unit harness connector and telescopic motor harness connector.

   Automatic drive positioner control unit		Telescopic motor		Continuity
   Connector	Terminal	Connector	Terminal
   M34	27	M94	5	Yes

4. Check continuity between automatic drive positioner control unit harness connector and ground.

   Automatic drive positioner control unit		Ground	Continuity
   Connector	Terminal
   M34	27		No

Is the inspection result normal?

YES

Replace automatic drive positioner control unit. Refer to Removal and Installation .

NO

Repair or replace harness.

1. Turn ignition switch OFF.
2. Disconnect automatic drive positioner control unit.
3. Check continuity between automatic drive positioner control unit harness connector and telescopic motor harness connector.

   Automatic drive positioner control unit		Telescopic motor		Continuity
   Connector	Terminal	Connector	Terminal
   M33	20	M94	3	Yes

Is the inspection result normal?

YES

Replace telescopic motor. Refer to Exploded View .

NO

Repair or replace harness.