Automatic Drive Positioner (DTC/Circuit Diagnosis)
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK TELESCOPIC MOTOR POWER SUPPLY
- Turn ignition switch OFF.
- Disconnect telescopic motor.
- Turn the ignition switch ON.
- Perform "ACTIVE TEST" ("TELESCO MOTOR") with CONSULT.
- Check voltage between telescopic motor harness connector and ground.
(+)
(-)
Condition
Voltage (V)
(Approx.)
Telescopic motor
Connector
Terminals
M94
2
Ground
TELESCOPIC MOTOR
OFF
0
FR (forward)
0
RR (backward)
Battery voltage
1
OFF
0
FR (forward)
Battery voltage
RR (backward)
0
Is the inspection result normal?
YES
Replace telescopic motor. Refer to Exploded View .
NO
GO TO 2.
- CHECK TELESCOPIC MOTOR CIRCUIT
- Turn ignition switch OFF.
- Disconnect automatic drive positioner control unit.
- Check continuity between automatic drive positioner control unit harness connector and telescopic motor harness connector.
Automatic drive positioner control unit
Telescopic motor
Continuity
Connector
Terminal
Connector
Terminal
M34
29
M94
1
Yes
26
2
- Check continuity between automatic drive positioner control unit harness connector and ground.
Automatic drive positioner control unit
Ground
Continuity
Connector
Terminal
M34
29
No
26
Is the inspection result normal?
YES
Replace automatic drive positioner control unit. Refer to Removal and Installation .
NO
Repair or replace harness.