Automatic Drive Positioner (DTC/Circuit Diagnosis)
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK RECLINING MOTOR LH POWER SUPPLY
- Turn the ignition switch to ACC.
- Perform "ACTIVE TEST" ("SEAT RECLINING") with CONSULT.
- Check voltage between driver seat control unit harness connector and ground.
(+)
(-)
Condition
Voltage (V)
(Approx.)
Driver seat control unit
Connector
Terminal
B210
43
Ground
SEAT RECLINING
OFF
0
FR (forward)
0
RR (backward)
Battery voltage
35
OFF
0
FR (forward)
Battery voltage
RR (backward)
0
Is the inspection result normal?
YES
Replace reclining motor LH. Refer to Removal and Installation .
NO
GO TO 2.
- CHECK RECLINING MOTOR LH CIRCUIT
- Turn ignition switch OFF.
- Disconnect driver seat control unit and reclining motor LH.
- Check continuity between driver seat control unit harness connector and reclining motor LH harness connector.
Driver seat control unit
Reclining motor LH
Continuity
Connector
Terminal
Connector
Terminal
B210
35
B217
6
Yes
43
4
- Check continuity between driver seat control unit harness connector and ground.
Driver seat control unit
Ground
Continuity
Connector
Terminal
B210
35
No
43
Is the inspection result normal?
YES
GO TO 3.
NO
Repair or replace harness.
- CHECK INTERMITTENT INCIDENT
Refer to Intermittent Incident .
Is the inspection result normal?
YES
Replace driver seat control unit. Refer to Removal and Installation .
NO
Repair or replace the malfunctioning part.