Automatic Drive Positioner (DTC/Circuit Diagnosis)

1. Turn ignition switch ON.
2. Check voltage between automatic drive positioner control unit connector and ground.

   (+)		(-)	Change over switch condition	Voltage (V) (Approx.)
   Automatic drive positioner control unit
   Connector	Terminal
   M33	2	Ground	RIGHT	0
   			Other than above	5
   	14		LEFT	0
   			Other than above	5

Is the inspection result normal?

YES

GO TO 5.

NO

GO TO 2.

1. Turn ignition switch OFF.
2. Disconnect automatic drive positioner control unit and door mirror remote control switch.
3. Check continuity between automatic drive positioner control unit connector and door mirror remote control switch connector.

   Automatic drive positioner control unit		Door mirror remote control switch		Continuity
   Connector	Terminal	Connector	Terminal
   M33	2	D57	28	Yes
   	14		23

4. Check continuity between automatic drive positioner control unit connector and ground.

   Automatic drive positioner control unit		Ground	Continuity
   Connector	Terminal
   M33	2		No
   	14

Is the inspection result normal?

YES

GO TO 3.

NO

Repair or replace harness.

Check continuity between door mirror remote control switch connector and ground.

Is the inspection result normal?

YES

GO TO 4.

NO

Repair or replace harness.

Check changeover switch.

Refer to Component Inspection .

Is the inspection result normal?

YES

Replace automatic drive positioner control unit. Refer to Removal and Installation .

NO

Replace door mirror remote control switch. Refer to Removal and Installation .

Check intermittent incident.

Refer to Intermittent Incident .

Is the inspection result normal?

YES

Replace automatic drive positioner control unit. Refer to Removal and Installation .

NO

Repair or replace the malfunctioning parts.