Automatic Drive Positioner (DTC/Circuit Diagnosis)
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- PERFORM DTC CONFIRMATION PROCEDURE
- Turn ignition switch ON.
- Check "Self diagnostic result" with CONSULT.
- Erase the DTC.
- Perform DTC confirmation procedure. Refer to DTC Logic .
Is the DTC displayed again?
YES
GO TO 2.
NO
Check intermittent incident. Refer to Intermittent Incident .
- CHECK RECLINING MOTOR LH CIRCUIT (POWER SHORT)
- Turn ignition switch OFF.
- Disconnect reclining motor LH and driver seat control unit connector.
- Check voltage between reclining motor LH harness connector and ground.
(+)
(-)
Voltage (V)
(Approx.)
Reclining motor LH
Connector
Terminals
B217
4
Ground
0
6
Is the inspection result normal?
YES
GO TO 3.
NO
Repair or replace harness or connector.
- CHECK DRIVER SEAT CONTROL UNIT OUTPUT SIGNAL
- Connect driver seat control unit connector.
- Check voltage between driver seat control unit harness connector and ground.
(+)
(-)
Voltage (V)
(Approx.)
Driver seat control unit
Connector
Terminals
B210
35
Ground
0
43
Is the inspection result normal?
YES
GO TO 4.
NO
Replace driver seat control unit. Refer to Removal and Installation .
- CHECK INTERMITTENT INCIDENT
Refer to Intermittent Incident .
Inspection End.