Wheel & Tire System (DTC/Circuit Diagnosis)
- CHECK BCM HARNESS CONNECTORS
Check BCM harness connectors for damage or loose connections.
Is the inspection result normal?
YES
Repair or replace connectors.
NO
GO TO 2.
- CHECK BCM POWER SUPPLY AND GROUND
Check BCM power supply and ground. Refer to Diagnosis Procedure .
Is the inspection result normal?
YES
GO TO 3.
NO
Repair or replace harness or connectors.
- CHECK REMOTE KEYLESS ENTRY RECEIVER POWER CIRCUIT
Check voltage between remote keyless entry receiver connector M86 terminal 1 and ground.
Remote keyless entry receiver
Ground
Voltage
(Approx.)
Connector
Terminal
M86
1
--
Battery voltage
Is the inspection result normal?
YES
GO TO 4.
NO
Repair or replace harness or connectors.
- CHECK REMOTE KEYLESS ENTRY RECEIVER SIGNAL CIRCUIT
- Turn ignition switch OFF.
- Disconnect BCM connector M80 and remote keyless entry receiver connector.
- Check continuity between BCM connector M80 terminal 119 and remote keyless entry receiver connector M86 terminal 2.
BCM
Remote keyless entry receiver
Continuity
Connector
Terminal
Connector
Terminal
M80
119
M86
2
Yes
- Check continuity between BCM connector M80 terminal 119 and ground.
BCM
Ground
Continuity
Connector
Terminal
M80
119
--
No
Is the inspection result normal?
YES
GO TO 5.
NO
Repair or replace harness or connectors.
- CHECK REMOTE KEYLESS ENTRY RECEIVER GROUND CIRCUIT
Check continuity between remote keyless entry receiver connector M86 terminal 3 and ground.
Remote keyless entry receiver
Ground
Continuity
Connector
Terminal
M86
3
--
Yes
Is the inspection result normal?
YES
GO TO 6.
NO
Repair or replace harness or connectors.
- CHECK BCM INPUT/OUTPUT SIGNALS
Check BCM input/output signals. Refer to Reference Value .
Is the inspection result normal?
YES
Inspection End.
NO
Replace BCM. Refer to Removal and Installation .