Diagnosis Procedure: Defogger
- CHECK DOOR MIRROR DEFOGGER FUSE
Check if the following fuse in fuse block (J/B) is blown.
COMPONENT PARTS
AMPERE
FUSE NO.
Fuse block (J/B)
10 A
22
Is the inspection result normal?
YES
GO TO 2.
NO
Replace the blown fuse after repairing the affected circuit.
- CHECK DOOR MIRROR DEFOGGER CIRCUIT
- Turn ignition switch OFF.
- Disconnect the following harness connectors.
- Fuse block (J/B) connector M4
- Door mirror LH D4 (without around view monitor), D6 (with around view monitor)
- Door mirror RH D107 (without around view monitor), D116 (with around view monitor)
- Check continuity between fuse block (J/B) harness connector and door mirror defogger harness connectors.
Fuse block (J/B)
Connector
Terminal
Door mirror
Connectors
Terminal
Continuity
M4
5P
D4 (LH without around view monitor)
1
Yes
D107 (RH without around view monitor)
D6 (LH with around view monitor)
7
D116 (RH with around view monitor)
- Check continuity between fuse block (J/B) harness connector M4 terminal 5P and ground.
Fuse block (J/B)
connector
Terminal
Ground
Continuity
M4
5P
No
Is the inspection result normal?
YES
GO TO 3.
NO
Repair or replace harness.
- CHECK DOOR MIRROR DEFOGGER
Check door mirror LH.
Refer to Component Function Check (without around view monitor) or Component Function Check (with around view monitor).
Check door mirror RH.
Refer to Component Function Check (without around view monitor) or Component Function Check (with around view monitor).
Is the inspection result normal?
YES
Check intermittent incident. Refer to Intermittent Incident .
NO
Repair or replace the malfunctioning parts.