Component Function Check
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK REAR WIPER STOP POSITION SIGNAL
CONSULT
- Select "WIPER" in "Data Monitor" mode of "BCM".
- Operate the rear wiper.
- Check that RR WIPER STOP changes to On and Off linked with the wiper operation.
Monitor item
Condition
Monitor status
RR WIPER STOP
Rear wiper motor
Stop position
On
Except stop position
Off
Is the inspection result normal?
YES
Rear wiper stop position signal circuit is normal.
NO
Refer to Diagnosis Procedure .