Component Function Check

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

CHECK FRONT WIPER STOP POSITION SIGNAL

CONSULT

Select "WIP AUTO STOP" in "Data Monitor" mode of "IPDM E/R".
Operate the front wiper.

With the front wiper operation, check the monitor status.

Monitor item	Condition		Monitor status
WIP AUTO STOP	Front wiper motor	Stop position	STOP P
		Except stop position	ACT P

Is the inspection result normal?

YES

Front wiper stop position signal circuit is normal.

Refer to Diagnosis Procedure .