LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 66 (Multi Av System (NAVI Without BOSE)) >> Multi Av (NAVI Without BOSE) >> DTC/Circuit Diagnosis >> U1310 Control Unit (Av) >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. PERFORM DTC CONFIRMATION PROCEDURE 

    SYMBOL CONSULT

    1. Turn ignition switch ON.
    2. Turn ignition switch OFF and wait at least 30 seconds.
    3. Turn ignition switch ON and wait at least 30 seconds or more.
    4. Select "Self Diagnostic Result" mode of "MULTI AV".
    5. Check DTC.

    Is DTC U1310 detected?

    YES

    Replace AV control unit. Refer to Removal and Installation .

    NO

    To check malfunction symptom before repair: Refer to Intermittent Incident .

    NO

    Confirmation after repair: Inspection End.

scientia non olet · About LEMON Manuals