Diagnosis Procedure

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

CHECK MOTOR SENSOR (RH) POWER SUPPLY

Turn the ignition switch OFF.
Disconnect power return motor assembly (RH) connector.

Check voltage between power return motor assembly (RH) harness connector and ground.

(+)		(-)	Condition	Voltage (V)
Power return motor assembly (RH)
Connector	Terminal
B417	2	Ground	When power return motor (RH) is operated	Battery voltage

Is the inspection result normal?

YES

GO TO 3.

GO TO 2.

CHECK MOTOR SENSOR (RH) POWER SUPPLY CIRCUIT

Disconnect seatback power return control unit connector B412.

Check continuity between seatback power return control unit harness connector and power return motor assembly (RH) harness connector.

Seatback power return control unit		Power return motor assembly (RH)		Continuity
Connector	Terminal	Connector	Terminal	Continuity
B412	1	B417	2	Yes

Check continuity between seatback power return control unit harness connector and ground.

Seatback power return control unit		Ground	Continuity
Connector	Terminal
B412	1		No

Is the inspection result normal?

YES

Replace seatback power return control unit. Refer to Removal and Installation .

Repair or replace harness.

CHECK MOTOR SENSOR (RH) GROUND CIRCUIT

Check continuity between seatback power return control unit harness connector and power return motor assembly (RH) harness connector.

Seatback power return control unit		Power return motor assembly (RH)		Continuity
Connector	Terminal	Connector	Terminal	Continuity
B412	8	B417	5	Yes

Check continuity between seatback power return control unit harness connector and ground.

Seatback power return control unit		Ground	Continuity
Connector
B412	8		No

Is the inspection result normal?

YES

GO TO 4.

Repair or replace harness.

CHECK MOTOR SENSOR (RH) OUTPUT SIGNAL

Connect seatback power return control unit connector B412.

Check signal between seatback power return control unit harness connector and ground with an oscilloscope.

(+)		(-)	Condition	Signal (Reference value)
Seatback power return control unit
Connector	Terminal
B412	7	Ground	During the power return motor (RH) operation	Courtesy of NISSAN NORTH AMERICA, INC.
			When pinching seatback occurs	The above pulse width should be expanded

Is the inspection result normal?

YES

GO TO 6.

GO TO 5.

CHECK MOTOR SENSOR (RH) SIGNAL CIRCUIT

Disconnect power return motor assembly (RH) connector and seatback power return control unit connector B412.

Check continuity between power return motor assembly (RH) harness connector and seatback power return control unit harness connector.

Seatback power return control unit		Power return motor assembly (RH)		Continuity
Connector	Terminal	Connector	Terminal	Continuity
B412	7	B417	4	Yes

Check continuity between seatback power return control unit harness connector and ground.

Seatback power return control unit		Ground	Continuity
Connector	Terminal
B412	7		No

Is the inspection result normal?

YES

Replace power return motor assembly (RH). Refer to Exploded View .

Repair or replace harness.

CHECK INTERMITTENT INCIDENT
Refer to Intermittent Incident .

Inspection End.