Component Inspection (Intake Air Temperature Sensor)
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK INTAKE AIR TEMPERATURE SENSOR
With CONSULT
- Turn ignition switch OFF.
- Disconnect mass air flow (MAF) sensor (intake air temperature sensor is built-into) harness connector and reconnect it.
- Turn ignition switch ON.
- On CONSULT screen, select "ENGINE">>"Data Monitor">>"INT/A TEMP SEN".
- Check that the indicated value of "INT/A TEMP SEN" is almost the same as intake air temperature.
Is the inspection result normal?
YES
INSPECTION END
NO
Replace mass air flow sensor (with intake air temperature sensor). Refer to AIR CLEANER AND AIR DUCT .