LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 645 (Engine Control System (DTC/Circuit Diagnosis) (3 Of 17)) >> DTC/Circuit Diagnosis >> DTC P00FE: EVAP Control System >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK EVAP CONTROL SYSTEM FOR CLOGGING 

    SYMBOL With CONSULT

    1. Turn ignition switch OFF.
    2. Disconnect EVAP purge hose SYMBOL from EVAP canister purge volume control valve.
      GNSJSBIB1848GB-848Courtesy of NISSAN NORTH AMERICA, INC.
    3. Disconnect fuel tank vent hose SYMBOL from EVAP canister.
    4. Turn ignition switch ON (engine stopped).
    5. On CONSULT screen, select "ENGINE" >> "Work support" >> "EVAP SYSTEM CLOSE".
    6. Apply pressure to the hose end SYMBOL using Vacuum/Pressure Handy Pump according to CONSULT screen.
    7. Check that the applied pressure is not raised or kept.

    Is the inspection result normal?

    YES

    Check fuel tank vent line for clogs, vent and installation condition.

    NO

    Replace EVAP canister. Refer to Removal and Installation .

scientia non olet · About LEMON Manuals