Component Inspection (Heated Steering Wheel)
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK HEATED STEERING WHEEL CONTINUITY
- Turn ignition switch OFF.
- Remove the steering wheel. Refer to Removal and Installation .
- Check continuity between steering wheel connector terminals.
Terminals
Condition
Continuity
1 - 2
Surface temperature of less than 30 deg. C (86 deg. F)
Yes
Surface temperature of 30 deg. C (86 deg. F) or more
No
Is the inspection result normal?
YES
GO TO 2.
NO
Replace heated steering wheel.
- CHECK HEATED STEERING WHEEL RESISTANCE
Check resistance between heated steering wheel connector terminals.
Terminals
Condition
Resistance
1 - 2
Surface temperature of 20 deg. C (68 deg. F)
1.7 - 2.17 Ohm
Is the inspection result normal?
YES
Inspection End.
NO
Replace heated steering wheel.