DTC Detection Logic
WARNING: This page is about a different car, the 2020 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
U1000 can be set if a module harness was disconnected and reconnected, perhaps during a repair. Confirm that there are actual CAN diagnostic symptoms and a present DTC by performing the Self Diagnostic Result procedure.
|
DTC No. |
CONSULT screen terms (Trouble diagnosis content) |
DTC Detection Condition |
|
|
U1000 |
CAN COMM CIRCUIT (CAN communication circuit) |
Diagnosis condition |
When push-button ignition switch is ON. |
|
Signal (terminal) |
-- |
||
|
Threshold |
When BCM cannot communicate with CAN communication signal continuously for 2 seconds or more |
||
|
Diagnosis delay time |
2 seconds or more |
||