LEMON Manuals: Even more car manuals for everyone
Home >> Nissan-Datsun >> 2021 >> NV2500 HD S >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Multi Av System (NAVI With BOSE) (DTC/Circuit Diagnosis)) >> DTC/Circuit Diagnosis >> Power Supply And Ground Circuit >> BOSE Speaker Amp >> Diagnosis Procedure

Diagnosis Procedure

WARNING: This page is about a different car, the 2018 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FUSE 
    1. Turn ignition switch OFF.
    2. Check that the following fuses are not blown:

      Power source

      Fuse No.

      Capacity

      Battery

      11

      15 A

      12

      15 A

      Ignition switch ACC

      21

      10 A

    Is a fuse blown?

    YES

    Replace the blown fuse after repairing the affected circuit.

    NO

    GO TO 2 .

  2. CHECK BOSE SPEAKER AMP. BATTERY POWER SUPPLY 
    1. Disconnect BOSE speaker amp. connector B110.
    2. Check the voltage between BOSE speaker amp. connector B110 and ground.

      BOSE speaker amp.

      Ground

      Voltage

      (Approx.)

      Connector

      Terminal

      B110

      10

      (-)

      Battery voltage

      11

    Is the inspection result normal?

    YES

    GO TO 3 .

    NO

    Repair or replace harness or connectors.

  3. CHECK BOSE SPEAKER AMP. ACCESSORY POWER SUPPLY 
    1. Disconnect BOSE speaker amp. connector B149.
    2. Turn ignition switch to ACC.
    3. Check the voltage between BOSE speaker amp. connector B149 and ground.

      BOSE speaker amp.

      Ground

      Voltage

      (Approx.)

      Connector

      Terminal

      B149

      53

      (-)

      Battery voltage

    Is the inspection result normal?

    YES

    GO TO 4 .

    NO

    Repair or replace harness or connectors.

  4. CHECK BOSE SPEAKER AMP. GROUND CIRCUIT 
    1. Turn ignition switch OFF.
    2. Check the continuity between BOSE speaker amp. connector B110 and ground.

      BOSE speaker amp.

      Ground

      Continuity

      Connector

      Terminal

      B110

      7

      -

      Yes

      12

    Is the inspection result normal?

    YES

    Inspection End.

    NO

    Repair or replace harness or connectors.