Diagnosis Procedure
- CONNECTOR CHECK
Check the AV control unit, Bose speaker amp. and front door speaker connectors for the following:
- Proper connection
- Damage
- Disconnected or loose terminals
Is the inspection result normal?
YES
GO TO 2 .
NO
Repair the terminals or connectors.
- CHECK FRONT DOOR SPEAKER SIGNAL CIRCUIT CONTINUITY (BOSE SPEAKER AMP.)
- Disconnect Bose speaker amp. connector B110 and suspect front door speaker connector.
- Check continuity between Bose speaker amp. connector B110 and suspect front door speaker connector.
Bose speaker amp.
Front door speaker
Continuity
Connector
Terminal
Connector
Terminal
B110
13
D3 (LH)
1
Yes
8
2
3
D103 (RH)
1
4
2
- Check continuity between Bose speaker amp. connector B110 and ground.
Bose speaker amp.
Ground
Continuity
Connector
Terminal
B110
13
-
No
8
3
4
Is the inspection result normal?
YES
GO TO 3 .
NO
Repair or replace harness or connectors.
- CHECK FRONT DOOR SPEAKER SIGNAL (BOSE SPEAKER AMP.)
- Connect Bose speaker amp. connector B110 and suspect front door speaker connector.
- Turn ignition switch to ON.
- Push AV control unit POWER switch.
- Check signal between the terminals of Bose speaker amp. connector B110.
Bose speaker amp. connector B110
Condition
Reference value
(+)
(-)
Terminal
Terminal
13
8
Audio signal output
3
4
Is the inspection result normal?
YES
Replace front door speaker. Refer to Removal and Installation .
NO
GO TO 4 .
- CHECK FRONT DOOR SPEAKER SIGNAL CIRCUIT CONTINUITY (AV CONTROL UNIT)
- Turn ignition switch to OFF.
- Disconnect Bose speaker amp. connector B149 and AV control unit connector M162.
- Check continuity between Bose speaker amp. connector B149 and AV control unit connector M162.
Bose speaker amp.
AV control unit
Continuity
Connector
Terminal
Connector
Terminal
B149
62
M162
2
Yes
42
3
63
11
43
12
- Check continuity between Bose speaker amp. connector B149 and ground.
Bose speaker amp.
Ground
Continuity
Connector
Terminal
B149
62
-
No
42
63
43
Is the inspection result normal?
YES
GO TO 5 .
NO
Repair or replace harness or connectors.
- CHECK FRONT DOOR SPEAKER SIGNAL (AV CONTROL UNIT)
- Connect Bose speaker amp. connector B149 and AV control unit connector M162.
- Turn ignition switch to ON.
- Push AV control unit POWER switch.
- Check signal between AV control unit connector M162 and ground.
AV control unit connector M162
Condition
Reference value
(+)
(-)
Terminal
Terminal
2
3
Audio signal output
11
12
Is the inspection result normal?
YES
Replace Bose speaker amp. Refer to Removal and Installation .
NO
Replace AV control unit. Refer to Removal and Installation .